Bali

Gas-fired hot water boiler
Through-the-wall venting for homes without chimneys or where the chimney cannot be used

Bali gas-fired, hot water boilers from CROWN meet the challenge of providing higher efficiency than many standard boilers for homes where the chimney cannot be used.

An integral draft fan system designed into the Bali permits venting directly through a wall. Rugged cast iron heat exchanger and stainless steel burners are backed by a lifetime limited warranty, and the simplicity of design and reliability ensures years of low maintenance operation.

The Bali is available in six sizes (from 61,000 to 229,000 BTU input) to serve both small and large homes and businesses. The attractive and durable two-tone, powder coated jacket encloses most of the controls and wiring for a sleeker appearance, and it can be installed on any non-carpeted combustible surface. The Bali meets all national standards, and the heat exchanger meets the specifications of the American Society of Mechanical Engineers.

The Bali is among a new series of designs that CROWN engineers have created for ease of use, constructed for long life and engineered to provide the most value for each energy dollar. That's CROWN's commitment to quality.

Bali has all these features for optimum performance and safety

For Performance:

	Cast iron heat exchanger with a lifetime limited warranty
	Stainless steel burners with a lifetime limited warranty
	Integral fan for side-wall venting
	Reliable Honeywell controls
	Appliance quality, powder-coated jacket
	Fiber-glass insulation to minimize wasteful heat loss
	High performance circulator
	Circulator isolation flanges for more convenient service
	Temperature/pressure gauge
	Drain valve
	Optional two-zone control with priority zoning for an indirect water heater

For Safety:

	Can be installed directly on non-carpeted combustible floors
	Fully assembled ready for installation
	Factory tested for flame quality, leakage, control system operation and overall performance
	Reliable electronic ignition for fuel efficiency
	Pressure switch detects venting problems
	Rollout switch detects heat exchanger blockage
	ASME relief valve (set at 30 psi)